Every tab is used to set the property of the related component. This section is composed by four tabs: Screw, Washer1, Whaser2 and Nut. The buttons included in this section enable you to save, remove or apply any saved setting. This enables you to recall them quickly in future sessions. The items included in this box enable you to save the current setting of the component. This button displays a dialog box containinginformation about the current tool.If you haven’t confirmed the placementbefore, the current component will be deleted. This button closes the dialog box and it terminatesthe command.When the dialog is closed, the state ofTriBall is controlled by the buttons describedbefore. This button updates the component and it closes thedialog box.This button updates the component and it confirmsthe placement inside the scene.If thebutton is checked and TriBall is active, TriBallwill stay active, otherwise TriBall is disabled. The check button at the top onthe right of the button controls the state ofTriBall after the confirm of placement. In this way the user canimmediately move the component in the right place.Clicking the button, the state of TriBall is toggledbetween on and off. This button is used to switch the state of TriBall.Usually, when a fastener is placed on the scene, theTriBall is switched on.Clicking this combo box the user can select theactive standard rule.At top of the dialog there are the buttons useful to control the placement of the component and a combo box used to select the Standard Rule.
0 kommentar(er)
